How to install custom menus in autocad

Support 0 contributions. Issue: You would like to create a deployment to install AutoCAD with a shortcut that will load a custom profile. See Start AutoCAD with different profiles for instructions on how to create a custom icon to launch a profile. This process can be used with either Network or Multi-seat Stand-alone Deployments. Once you have a custom icon and an exported profile ARG file, use the following steps to configure your deployment: Install and run the Autodesk Deployment Wizard.

This option is only available in AutoCAD and based products. Highlight the Installation directory folder and click Select Files. Click Add Drive. Jitesh Dange. The list expands and you see a new panel called Panel1 at the bottom of the Panels list. The name Panel1 is highlighted and ready to be edited. Replace Panel1 by typing My Panel to give your panel a distinct name As you type, the name changes.

If you decide to change a panel name later, right-click a panel listing and then choose Rename. You now have a custom Ribbon panel. In the Command List group, locate the command that you want to add. In this instance, locate the Line tool. This will control the appearance of your pull down menus. If you want to add some more pull down menus, then you have to create additional POP sections or else you can add some more options of one of the existing section, by adding additional codes.

Now go as below:. From the fourth line to the end of the codes are the actual codes for creating the concentric circles. Please notice that this is very much similar to autocodes lisp with some additions.