Adjusting the Keypad Sounder Tone and Backlighting Previous Page. Next Page. Press the PC Control Panel onto the nylon mounting studs.
Pull all cables into the cabinet and prepare them for connection. If the neutral in the main supply is not readily identifiable, then an appropriate disconnect device that has a contact separation of at least 3mm and disconnects both poles simultaneously, must be used.
In order to comply with safety requirement IEC, ensure that when the mains cabling enters the alarm panel, it is securely clamped to prevent it from being removed.
The Master Code is used to arm and disarm the panel, to silence the sounder after an alarm, and to program additional Access Codes. To silence the sounder, press the [ ] Key; Note that the alarm memory will be cleared the next time the system is armed. These commands are described in detail in the Programming Section of this manual. The panel can only be programmed while it is disarmed. When programmed as [0] Audible, the siren will sound on alarm; when programmed as [1] Silent, the siren will not sound on alarm.
Note that zone response times are factory set at ms. Page System Times [02] System Times Three system times are programmed in Section [02]; each time requires a 3-digit number. Do not press the [ ] Key during data entry. Page First System Option Code After one or two rings, the downloading computer must hang-up the line and then place another call to the PC within 60 seconds. The PC will then answer the second call on the first ring.
Then, assign the other zone types to the remaining zones in any order desired. Digit 1 Digit 2 Default [0] Audible The smoke detectors Note to Installers may have been improperly installed or positioned. Smoke may not be able to This warning contains vital information. O DLS-1 V5. The entire manual should be carefully read. Print page 1 Print document 27 pages. Press the PC Control Panel onto the nylon mounting studs.
Pull all cables into the cabinet and prepare them for connection. Burglary Zone Wiring Burglary zone definition, for example, Delay, Instant, Hour, and so on is programmed using the keypad. Refer to Programming Guide Section [01]. NOTE: To help prevent false alarms, all zones are automatically bypassed for seconds on power-up to allow detectors to settle. This output will be activated when a zone alarm or tamper alarm is generated while the system is armed.
The output will remain activated until the system is disarmed. The Master Code is used to arm and disarm the system, to silence the bell or siren after an alarm, and to program additional Access Codes. To silence the sounder, press the [ ] Key; These commands are described in detail in the Programming Section of this manual. Call DSC Australia if you are attempting to take over a system installed by another security company. When programmed as audible, the siren will sound on alarm; when programmed as silent, the siren will not sound on alarm.
Note that zone response times are factory set at ms. Page System Times [02] System Times Three system times are programmed in Section [02]; each time requires a 3-digit number. Do not press the [ ] Key during data entry.
Entry Delay to seconds The Entry Delay determines the amount of time permitted between the activation of a Delay Zone and the disarming of the system. The system must be called by the downloading computer, and the computer must allow the telephone line to ring only once or twice. Enter the telephone number the same way it would be dialled on a touch-tone phone. Press [ ] after the last digit to complete the telephone number programming.
Page Programming Worksheets PC v1. Page 21 PC v1.
0コメント